UC3854B Status:ACTIVE

Product Information

Features

• Controls Boost PWM to Near-Unity Power Factor
• Limits Line Current Distortion To <3%
• World-Wide Operation Without Switches
• Accurate Power Limiting
• Fixed-Frequency Average Current-Mode Control
• High Bandwidth (5 MHz), Low-Offset Current Amplifier
• Integrated Current- and Voltage-Amplifier Output Clamps
• Multiplier Improvements: Linearity, 500 mV V_AC Offset (Eliminates External Resistor), 0 V to 5 V Multout Common-Mode Range
• V_REF GOOD Comparator
• Faster and Improved Accuracy ENABLE Comparator
• UVLO Options (16 V/10 V or 10.5 V/10 V)
• 300-µA Start-Up Supply Current

Description

The UC3854A/B products are pin compatibleenhanced versions of the UC3854. Like the UC3854, these products provide all of the functions necessary for active power factor corrected preregulators. The controller achieves near unity power factor by shaping the ac input line current waveform to correspond to the ac input line voltage. To do this the UC3854A/B uses average current mode control. Average current mode control maintains stable, low distortion sinusoidal line current without the need for slope compensation, unlike peak current mode control.

A 1%, 7.5-V reference, fixed frequency oscillator, PWM, voltage amplifierwith soft-start, line voltage feedforward (V_RMS squarer), input supply voltage clamp, and over current comparator round out the lilst of feataures.

Available in the 16-pin N (PDIP), DW (SOIC Wide), and J (CDIP) and 20-pin Q (PLCC) package. See Ordering Information table for availability by temperature range.

The UC3854A/B products improve upon the UC3854 by offering a wide bandwidth, low offset current amplifier, a faster responding and improved accuracy enable comparator, a VREF GOOD comparator, UVLO threshold options (16 V/10 V for offline, 10.5 V/10 V for startup from an auxiliary 12-V regulator), lower startup supply current, and an enhanced multiply/divide circuit. New features like the amplifier output clamps, improved amplifier current sinking capability, and low offset VAC pin reduce the external component count while improving performance. Improved common mode input range of the multiplier output/current amplifier input allow the designer greater flexibility in choosing amethod for current sensing. Unlike its predecessor, R_SET controls only oscillator charging current and has no effect on clamping the maximum multiplier output current. This current is now clamped to a maximum of 2 × I_AC at all times which simplifies the design process and provides foldback power limiting during brownout and extreme low line conditions.